In this Dell laptop tutorial we are going to show you how to install and replace the Modem Card on your Dell Latitude D620 laptop. These installation instructions have be made into 16 easy to follow printable steps. We have also create a video tutorial that shows you how to install your Dell Latitude D620 Modem Card.
Before you begin
Dell repair manual service precautions
Tools needed for this laptop repair
- 1 x small phillips head screw driver
- 1 x small plastic scribe
|
DIY Discount - Parts-People.com offers 5% off to all DO-IT-YOURSELFERS!
Use this coupon code to save 5% off these parts DIYM514
|
Video tutorial repair manual
Installation and Removal Instructions
Dell Latitude D620 Modem Card
Step 1
- Slide the battery latches over.
- Slide the battery down and lift out of the laptop.
Step 2
- Unscrew the retaining screw and remove the door from the laptop
Step 3
- Remove the (2) 3mm x 3mm hard drive screws.
- Slide the hard drive out of the laptop.
Step 4
- Remove the 2mm x 5mm optical drive latch locking screw.
- Press in the optical drive latch to get it to eject.
- Pull the latch to slide the optical drive out of the laptop.
Step 5
- Remove the (2) 2.5mm x 5mm bottom hinge screws.
- Remove the (2) 2.5mm x 5mm hinge screws on the back edge of the laptop.
Step 6
- Loosen the 2 non-removable PCI slot screws.
Step 7
- Unscrew the (7) 2.5mm x 8mm base screws.
Step 8
- Turn the laptop over and open it as wide as possible, approximately 180 degrees.
- Using a flat head screwdriver, pry up the power button cover using the slot on the right side.
- Carefully unsnap the power button cover, starting from the right and working your way left.
Step 9
- Remove the (3) 2mm x 3mm screws.
- Carefully lift the keyboard and turn it over to reveal the keyboard cable.
Step 10
- Unhook the keyboard cable retaining clip by pivoting the blue clip up.
- Unplug the keyboard cable by lifting the blue ribbon straight up.
Step 11
- Disconnect the WLAN antenna cables.
- Disconnect the WWAN antenna cables.
Step 12
- Unplug the LCD cable.
- Loosen the antenna cables and LCD cable from the routing channels.
- Lift the LCD display assembly away from the laptop base.
Step 13
- Unscrew the (3) 2.5mm x 8mm palm rest screws.
Step 14
- Unplug the CMOS battery.
Step 15
- Unplug the palm rest. The cable is located under the left edge of the palm rest.
- Lift the palm rest from the base.
Step 16
- Unscrew the 2mm x 3mm modem screw.
- Unplug the modem cable.
- Unplug the modem from the motherboard.
|
DIY Discount - Parts-People.com offers 5% off to all DO-IT-YOURSELFERS!
Use this coupon code to save 5% off these parts DIYM514
|