In this Dell laptop tutorial we are going to show you how to install and replace the USB Circuit Board on your Dell Inspiron 15R (5520 / 7520) laptop. These installation instructions have be made into 16 easy to follow printable steps. We have also create a video tutorial that shows you how to install your Dell Inspiron 15R (5520 / 7520) USB Circuit Board.
Before you begin
Dell repair manual service precautions
Tools needed for this laptop repair
- 1 x small phillips head screw driver
- 1 x small plastic scribe
|
DIY Discount - Parts-People.com offers 5% off to all DO-IT-YOURSELFERS!
Use this coupon code to save 5% off these parts DIYM514
|
Video tutorial repair manual
Installation and Removal Instructions
Dell Inspiron 15R (5520 / 7520) USB Circuit Board
Step 1
- Slide the latches over and lift the battery out.
Step 2
- Loosen the screws and remove the access door (cannot be removed).
Step 4
- Remove the hard drive screws (4 x M2.5 x 5mm).
- Using the tab, slide the hard drive out of the laptop.
Step 5
- Separate the clips and remove the memory stick.
- Separate the clips and remove the second memory stick.
Step 6
- Remove screws under battery (4 x M2x2.5mm).
- Remove the screws on bottom base (5 x M2.5x6mm).
- Remove the screws under the DVD optical drive (2 x M2 x 3mm).
Step 7
- Turn the laptop over and open it up.
- Using a small flathead screwdriver, press in the 4 keyboard latches and lift the keyboard up.
- Unplug the keyboard cable.
Step 9
- Using a scribe or a flathead screwdriver, separate the palmrest from the laptop base.
- Unplug the cable under the palmrest.
Step 10
- Remove the DC jack bracket screws (2 x M2.5 x 5mm).
- Remove the DC jack bracket.
- Unplug the DC jack cable & remove the DC jack.
Step 11
- Unplug the fan cable.
- Remove the fan from the laptop.
Step 12
- Unplug the SD card reader cable.
- Unplug the speaker cable.
Step 13
- Remove the motherboard screws (2 x M2.5 x 5mm).
- Remove the motherboard.
Step 14
- Unplug and loosen the wireless antenna cables.
- Unplug and loosen the display cable.
- Remove the WLAN Wi-Fi card screw (1 x M2 x 3mm).
- Remove the WLAN Wi-Fi card.
Step 15
- Remove the left hinge screws (3 x M2.5 x 5mm).
- Remove the right hinge screws (2 x M2.5 x 5mm).
- Remove the display assembly.
Step 16
- Remove the USB circuit board screws (1 x M2.5 x 5mm).
- Lift the USB circuit board out of the laptop.
|
DIY Discount - Parts-People.com offers 5% off to all DO-IT-YOURSELFERS!
Use this coupon code to save 5% off these parts DIYM514
|