Dell Latitude 5521 How-To Install & Replace Your LCD Hinges

By Ricardo on January 2, 2024 · 5:18 pm

In this Dell laptop tutorial we are going to show you how to install and replace the LCD Hinges on your Latitude 5521 laptop. These installation instructions have been made into 9 easy to follow printable steps. We have also created a video tutorial that shows you how to install your Latitude 5521 LCD Hinges.

Before you begin

Please take the time read the following safety guidelines when working on static sensitive electrical components.
Dell repair manual service precautions

Tools needed for this laptop repair

1 x Phillips #0 screwdriver
1 x small plastic scribe

Latitude 5521 Hinges

Dell Laptop Replacement Parts Needed

DIY Discount - Parts-People.com offers 5% off to all DO-IT-YOURSELFERS!

Use this coupon code to save 5% off these parts

DIYM514

Latitude 5521 LCD Hinges

Video tutorial repair manual

Installation and Removal Instructions
Latitude 5521 LCD Hinges

Before you begin: If you need help at any point, you can always contact Parts-People Repair Department for help with your diagnosis or repair.

Step 1

Before you begin: If you need help at any point, you can always contact Parts-People Repair Department for help with your diagnosis or repair.

Use a Phillips Screwdriver to unscrew the

Step 2

Use a Phillips Screwdriver to unscrew the Bottom Base (9 x captive screws).
Use a Plastic Scribe to pry apart and remove the Bottom Base Cover.

Step 3

Disconnect the Battery.

Unscrew and remove the Wifi bracket (1 x captive screw).

Step 4

Unscrew and remove the Wifi bracket (1 x captive screw).
Disconnect the antenna cables.
Slide out the WiFi Card.

Unscrew and remove the LCD cable bracket.

Step 5

Unscrew and remove the LCD cable bracket.
Pull out the 1st LCD cable connector.
Unsnap the locking clip and pull out the 2nd LCD cable connector.
Pull out the 3rd LCD cable connector.

Unscrew the hinges and then open up the LCD assembly (6 x M2.5 x 5mm).

Step 6

Unscrew the hinges and then open up the LCD assembly (6 x M2.5 x 5mm).
Separate the LCD assembly from the Palmrest.

Insert a plastic scribe into the hinge cover openings and separate the LCD Bezel from the

Step 7

Insert a plastic scribe into the hinge cover openings and separate the LCD Bezel from the LCD Back Cover.
Carefully work your way around unsnapping it until it's fully detached.